Mechanized line for cutting ends and drilling holes in frozen semi-finished products (workpieces for French "hot-dogs") model МСО -3

Comments

   Purpose and operating conditions of the model МСО-3:

The mechanized line is intended for cutting ends and drilling holes in frozen semi-finished products (workpieces for French "hot-dogs"). The technological process is as follows: workpieces are manually put into a technological conveyor. The movement of the conveyor occurs discretely at 9 positions. During movement, the ends are cut off with a disk knife. During the stop automatic drilling is performed. Drilled workpieces are manually removed from the cassettes and put into packaging. When drilling through aspiration waste enters the receiver of air cyclone and cut off particles move into a special bunker near the saw.
Operating conditions: exterior temperature  +5...+10°С; relative humidity of the outside air, not more than  80%.

 

Main technical characteristics of the model МСО-3:

Maximum performance 3500 - 5500 pc/hour
Overall dimensions of the products to be cut and drilled: - length maximum* 210 mm ± 10 mm
- diameter maximum* 55 mm ± 2 mm
Length of product after cutting edge* 180 mm ± 5 mm
Diameter of a hole (a hole should be placed in the center)* 24 mm ± 1 mm
Accuracy of centering a hole (deviation in plane from center to radius) ± 2 mm
Depth of a hole* 130 mm – 160 mm ±5 mm
Power source: – power grid, three-phase 380 В, 50 Hz
Power delivered 2,5 kW
Overall dimensions: – width 1404 mm
– height 1845 mm
– length 4008 mm
Pressure delivered to pneumocylinders 0,6 mPa

































*  - Dimensions are specified when compiling a technical specification

Всі права захищено. © Буліт 2013 – 2018. Створення сайту - студiя "sites creating by Nichol"